Solid glass corners

Open a position.
In the grid input, on the "Edit" tab, click "Solid glass corners" to create a solid glass corner including PSI values:
In the position drawing, select the mullion for the solid glass corner and click "Apply" on the ribbon:
Select whether the solid glass corner is an "outer corner" or an "inner corner":

Note:
The centre line of the solid glass corner refers to the exterior edge of the glazing plane.

Under "Type of solid glass corner", select one of the following options:
- Left pane smaller, without step
- Right pane smaller, without step
- Left pane smaller, right pane step glass
- Right pane smaller, left pane step glass
- Symmetric without step
- Symmetric with step
Under "Angle of folding", enter the degree of the angle to be folded.
Under "Gap between panes", enter the distance between the panes in mm.
Click "Ok".
To return to grid input, click "Close" on the ribbon:

Was this article helpful to you? Yes No