Add single part door insertion
- Click "Single part door insertion" in the insertion selection:
- Select a field in the position drawing.
- Enter the basic data:
Note:
The lower transom is usually removed with insertion doors. If this one shall stay, only the highlighted bottom configurations will be available. Then the upper edge of the transom is the reference to FFL.
- Select "Remove lower transom" if you want to remove the lower transom of the insertion.
- Click "OK" to continue. The following steps are identical to the input of elements.
Add multi part door insertion
- Click "Multi part door insertion" in the insertion selection:
- The following steps are similar to the insertion of a single part door insertion.
Deutsch
English (UK)
Français
Italiano